Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
In FTD v7.6.2 I have and access rule to block incoming traffic with destination port ssh,rdp and telnet. but,upon checking the logs, traffics was block using this rule with destination ports for others not specified in the rule(dns, snmp,ldap etc...
Hi!
I'm migrating ASA to FTD 3110. I got an issue during validation where "OSPF configuration already exists on the cisco FMC. Please disable OSPF on the FMC before proceeding with the migration." I am migrating a transparent mode FW and there is no ...
We have multiple VRFs in an aci and we are need inter VRF EPG-EPG communication to pass through a single FW by using Service Graph. Challenge is you can assoiciate service graph in to a single Bridge Domain which only have a single VRF. So there is a...
Have you tried vAPIC in vmware using standard vswitch, what is your setting?
our vAPIC can't discover 1st leaf switch. there is no output using (none)# tcpdump -ni kpm_inb port 67 or 68 but there is lldp traffic when using show lldp traffic.
Also is...
Have you experienced that you can't open or edit some profile in posture resources? errors says 'This profile is currently not supported for modification in ise'Others files can be opened without a problem.
as per checking the option can be seen on the Device Managment->Device->Routing-OSPF. am I right? but on the FTD device there is no option for OSPF yet.
Hi @Wassim Aouadi ,
Yes, this is exactly the challenge. let's say I have 3 vrfs (VRF1,2,3) and I need all inter vrf communication to pass through a firewall. let's say service bd is in vrf 1, but i need a service graph for vrf 2- vrf 3 communication....
