Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I need two EEM scripts one to remove an EIGRP network statement when an IP SLA reach-ability is down, and one to remove a EIGRP network statement when I lose an EIGRP neighbor. I started to configure something (pasted below), but they aren't activ...
I haven't worked with EEM scripts too much so I don't even know if what I want is plausible. After looking around it seems like it should be.Basically I want my router to ping a device and if it drops 15 packets in 1 min to change the OSPF cost on 3 ...
This is the final config i came up with does anyone have any better ideas?basically i have a ping every 1 sec and after 10 secs it sends a log that the EEM script uses to execute the command to change the OSPF cost. After 120 secs (2 Mins) of it bein...
"
If the ping is not successful, as shown in Example 3-10, you should use the technologies discussed in Chapter 2, “Troubleshooting Basic Connectivity.” First, check the cabling and verify that the interfaces on connected devices are on a common subn...
If you type show vpc peer-keepalive does it say success for everything?Also"vPC Peer-Switch Since NX-OS 4.2(6), 5.0(2a) and further, an enhancement, called vPC peer-switch, was brought to STP in the context of vPC. The vPC Peer-Switch feature (Figure...
