Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,Been trying to connect cisco switch with acesspoint using vlan i have created vlan 40 with ip 10.1.1.1 and dhcp range of 10.1.1.10 to 10.1.1.30 i could able to get the same vlan ip range on my computer while connecting to the port.. but if crea...
hello, i have been using cisco switch sg350 trying to create two vlan and two trunk port to connect with one acess point vlan 1 should trunked with vlan 30-->router 192.168.1.1 netmask 255.255.255.0 should get internet with dhcp from tplink router i...
hello,having sg350 switch with 28 ports been trying to configure a vlan for both acess port and trunk port with dhcp server 1)like i want my port 2 to port 8 as my vlan 2 2)and 23 to 27 as my trunk port with vlan 30 and dhcp server with default gatew...
hello i have been using yuncore access point and i have tired to cdp but that also did not working and tired to add static route is this correct way ip configuration ->ipv4 interface interface VLAN 40 ip address ->10.2.2.10 netmask-->255.255.255.0 (v...
Hello,i want setup to be like below image connect router lan to switch trunk port to acess internet and then acess port to acess point through tagged trunk port and also i i have been using web interface for configuration not command line using ip ...
