Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a connection in my router that will staticly translate the sourec and destination of a packet and then send it over the GRE tunnel.Original packet S-10.10.10.10 D-10.20.20.20XLATE routerDesired packetGlobal Packet S-172.16.10.10 ...
I have a switch port that goes into a blocking state after the upstream switch is rebooted. I have to bounce the root port to get it in forwarding. Loopguard is on globally. Any ideas? %SPANTREE-2-LOOPGUARD_BLOCK: Loop guard blocking port!sp...
I believe I have found the issue. There is a static route in the configuration for the local outside address pointing out another interface. I am assuming the router would route the traffic first and then translate still on the outbound interface.W...
It makes it a little tougher b/c I don't mange the other switch. I just don't quite understand why the port stays in a blocking state after the port comes back up. Would it be easier to configure my port with portfast or bpduguard to resolve the is...
