Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two C6509-E switch outfitted with one FWSM per each. And use vlan 200 for outside between C6509 and FWSM. the snapshot of configure are as follows, but i can't ping the SVI of vlan 200 from FWSM. However "show arp" on c6509 indicate that C6509...
dose anyone sucessfully install the ACS 4.0 on the chinese version of Win2003 Ent? does it need any additional packages or patches related to windows OS?
There are two CE1 Line between HQ and Branch office router. Router in HQ is Cisco 7204VXR with PA-MC-STM-1SMI card and Router in Branch is Cisco 7204VXR with two CE1 cards. After use the following configuration to bundle two CE1 link to improve the b...
I config the static nat in pix and use global / nat command to make source nat for inside host's internet connection. But when i try to connect the map ip config in pix as static ip, it dosen't work. I sniffor the packet and find the the source ip ad...
thanks. but so many of guyes told me that you certainly encoutner problem when operated on chinese version 2003 OS. I will try it first, if failed, i have to change the os.
in my config, the context-a is the admin-context and I have added the "permit ip any any" ACL both in outside and inside interface. So why still need add icmp related ACL? In addition, I restore the multiple context mode to single context mode and al...
thanks for your reply.I just changed to use ospf two equal-cost path to load balance. Although the load balance isn't very accurate as mlppp, it work. So customer at least accept this method. By the way, in the trouble shooting phase, i try to turn o...
