Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
use the clock rate command under the dce interface.That will clock out packets out based on the clock speed hence if you configure clock rate 64000 (as opposed to higher clock rates) you will notice slower response from the far end.It's not scientif...
Hi,Have you thought about Local Area Mobility?It's very easy to configure and supported by EIGRP.http://www.cisco.com/en/US/tech/tk722/tk721/technologies_white_paper09186a00800a3ca5.shtmlThe interface that has mobile hosts on it has to be enebled wit...
I bundled in the past 6 E1's on two routers (3 on each router at each end) and run VoIP (for a call centre) with no problems at all. I used CEF to ensure per session load balancing.HTHE.
When you use vlan maps you have to be careful to allow ARP traffic and in multiple switch networks (not relevant in your case) STP traffic. The last vlan map statement if configured will have a default action forward. If not defined or not explicitel...
