What is the FTD avpair configuration required when trying to setup radius with ISE and FTD cli access? I am getting an accept-accept in the live logs but users ssh session closes automatically..
Turned off but still receiving alerts to FMC for both... the FTDs are in the correct Health policy#Also turned Cisco Cloud Support off and still getting alert on FMC..
I have two sites one has a working AnyConnect solution 192.168.250.96 the other is not working 10.102.64.94.After review the RAVPN configuration I am sure it is correct but I have identified a possible routing issue for the AAA server. As you can see...
Hi,I am looking to use flex configuration to push a subnet traffic down a 3 VTI tunnels in ECMP.I am wanting the traffic to be load balanced or round robin. How is this achievable if each VTI has a different tunnel IP.
The imported route is to the outside but I have no idea where this is coming from?I have tested from a working FTD on another network and the PBR there is picking up the next hop.Why is this not on mine?
I have setup PBR and ran a packet capture here are the results. I am unsure if the traffic for 10.167.0.0/19 is being pushed down the VTI tunnels or just leaving the OUTSIDE interface. As mentioned the VTIs use the OUTSIDE interface so would they sho...