Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
VPN between our palo alto and client's meraki is up. but only one subnet of the client out of 4 is reachable. Subnets are added on both sides of the VPN. What could be the issue?Really need your help here
Hello All, I need your help again. So, we manage one of our client's WAN router which is a Cisco 1121-4P router.Flex anyconnect VPN is configured on it.The issue is that users sometimes get disconnected randomly and get the attached error when they t...
We have an ikev1 site-to-site VPN between client's Meraki and our Palo ALto.The issue is as follows :The VPN goes down after the phase 2 lifetime expires and doesn't renegotiate on its own.It only comes up when the traffic is initiated from Meraki's ...
Hi Team, I am trying to migrate the configuration from a CISCO 891 IOS router to CIsco 1121 IOS XE router.It is a pretty old router and has Cisco VPN client configured on it.Can we configure the same on the CISCO IOS XE 1121-4P router?Refer to the di...
No Sir.. It's still kicking out users and allowing them to log back in only after the Cisco 1121-4P router is rebooted.I am struggling to find a permanent fix. When I googled, I came across this article as the closest answer to my problem. I have imp...
Sir, I switched to ikev1 and I could communicate with all of their VLANs.But, when I changed the peer id from its primary IP address to their FQDN. It isn't working anymore.Please help
Okay. A part of the problem is fixed.I can reach both the subnets when I switched over to ikev1.Now, I have to configure VPN failover on Palo Alto.I have created two tunnels to each of their WANs.Does Meraki need to configure two separate tunnels fro...
