Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm looking to change the hubs that we have set for a grouping of config templates. Is there an API call that would be able to do this for the config templates? I'm able to do it for a single network - but if I enter the template ID into that same sc...
Is there an API call to get/set a networks VPN exclusion rules? I've been searching everywhere I can find, but I cannot seem to locate anything.I was planning on deploying a longer list of subnets to many locations and it would be much easier if it c...
I'm attempting to grab the public IP address off of a few interfaces for a specific networks in our organization but I'm struggling to get this completed.I'm using the /appliance/uplink/statuses call and trying to filter by network using ?networkIds=...
That's unfortunate. We have around 20 templates that needed to be modified, so I was really hoping that I wouldn't have to do that manually.Thank you very much for the response!
As of right now I just have one network ID listed in thereExample:$endpoint = 'https://api.meraki.com/api/v1/organizations/123456/appliance/uplink/statuses?networkIds=L_1234567890'
