Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How to config CE500 without console port? I know CNA can do it. But how to config it the first time? Only after I know the IP address or SNMP information of CE500, CNA can connect it. But what's the factory default CE500? And more, do CE500 support V...
How to config CE500 without console port? I know CNA can do it. But how to config it the first time? Only after I know the IP address or SNMP information of CE500, CNA can connect it. But what's the factory default CE500? And more, do CE500 support ...
now ,when started the 6509 auto enters into ROMMON mode. when started ,it prompts:(slot 5 is sup-720 moduel)FABRIC-SP-5-CLEAR_BLOCK: Clear block option is off for the fabric in slot 5.00:01:18: %FABRIC-SP-5-FABRIC_MODULE_ACTIVE: The Switch Fabric Mod...
Tanks for amit-singh.I will test today. But for Question1,I'm confused.For example,now I enable backup interface for serial link.If the serial link traffic is saturated, its backup interface--ethernet link will go up and now there are 2 router links ...
For dezoconnor:The inbound calls has been presented by Telco bacause the calling party number is displayed on my IP phone. But I can't find this information on voice gateway by debuging isdn q931.
