Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello guys, there is one scenario where i am stuck. We have extended cable from ISP's MUX to port 5 of L2 switch. i have created vlan 10 on switch and port 5 is member of it. when i pinged next hop it is not working. then I checked with ISP, they sai...
Guys, some issues are faced when L2 switch is connected in between Firewall and MPLS Router. We have IPSEC tunnel built over mpls link. When switch is placed we can't ping router LAN interface IP from active firewall, but once we remove it becomes di...
Hello Guys, we are implementing cross Stack ether channel but has some queries before implementing it. Refer attached diagramsplanning will be to connect cable from 9200 switch to Stack1 & Stack 3 member & from 3850 switch connect cable to Member1 & ...
Where are you pinging from - pinging next hop from firewall. Is that device also on a port assigned to vlan10, :- yes in diagram both ports 5 and 6 are members of vlan 10What status is port 5 when connected to the MUX? Does it negotiate to the right ...
Actually on port 46 of switch we have connected cable from router LAN interface so we see mac address of routerso when there is no traffic no mac address on switch port 46 as well. ideally when we connect rtr on switch port, mac address remains const...
