About jakmor

jakmor · 05-18-2023

Hey Everyone!I came across a problem with assigning addresses for VPN users via an external DHCP windows server 2016 instead of the local Address-pool.I specified the dhcp server in the profile settings and the network range in the group policy.I als...

jakmor · 04-28-2023

Hello All!I have come across a strange problem related to SCEP.I have an S2S/IPSec tunnel set up with GCP. It is based on VTI. At GCP, I have a CA on Windows Server, in the x.x.x.x.x subnet.When I try to set the SCEP Forwarding URL http://x.x.x.x/cer...

jakmor · 05-31-2023

ASA and DHCP server are direct connected. There is only one L2 switch between them.Route between DHCP and AnyConnect VPN works properly.Packet tracer below:Latest config:group-policy TEST-POLICY internalgroup-policy TEST-POLICY attributeswins-server ...

jakmor · 05-22-2023

Hello,I tested it when subnet 192.168.0.0 was empty. Unfortunately the same problem ;/But this time, when I tried to connect using AnyConnect, the connection stopped on "Establish VPN session..." and after a while the same error as before was display...

jakmor · 05-19-2023

I will wait until tomorrow until everyone disconnects from the local pool, I will delete it and then test with DHCP.I'll let you know if it helped on Monday.

jakmor · 05-19-2023

So I have to create new test subnet.New NAT, ACLI'll let you know

jakmor · 05-19-2023

just don't want to delete the local pool until I make a new profile configured to DHCP.

Member Since	‎04-28-2023 03:00 AM
Date Last Visited	‎07-07-2023 03:01 AM
Posts	23
Total Helpful Votes Received	8

User Statistics

User Activity

Anyconnect VPN and DHCP

SCEP Through S2S VPN (Using VTI)

Re: Anyconnect VPN and DHCP

Re: Anyconnect VPN and DHCP

Re: Anyconnect VPN and DHCP

Re: Anyconnect VPN and DHCP

Re: Anyconnect VPN and DHCP