Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two ASA application (9.8) Active/Standby on two Firepower 4110. We detected a failed state on the Standby ASA. On the Active we are seen this message:Number of interfaces on Active and Standby are not consistent.If the problem persists, you s...
Hi,Thank you for your reply, we double checked the interfaces, we even applied no monitor-interface on all the interface.. on all context, but still the same message:If the problem persists, you should disable and re-enable failover on the Standby.Nu...
Thank your for your reply and I suppose it's the same for securityk9 since it's giving me the same output:
Index 3 Feature: securityk9 Period left: Life time License Type: RightToUse License State: Active, In Use License Count: Non-Counted License P...
But for a 4321 :
Sh license
Index 1 Feature: appxk9 Period left: Life time License Type: RightToUse License State: Active, In Use License Count: Non-Counted License Priority: Low
Are you sure it will run out??
In IOS, I often check the acl counters to verify my configuration therefore I count on them for troubleshouting reasons. Now I'm using cisco xr so I have to use rpl and prefix-set, what would be the alternative of such functionality? (If there is a h...
I really appreciate your reply !
This worked perfectly!!
ipv4 access-list acl1 permit x.x.x.x permit z.z.z.z
class-map type traffic class1 match access-group ipv4 acl1end-class-map
policy-map type pbr policy1 class type traffic class1 set de...
