Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm trying to load a config file from a USB drive.When I try to connect the USB Stick with the 2960 switch I get the following error: %USB_HOST_STACK-5-USB_ENUM_FAIL_GETDESCR: Failed to enumerate a USB device as not able to read the device's desc...
Further Update:I've tried another drive from a different brand, formatted it to both FAT32 and FAT16 and both times i got the following error:May 4 13:42:15.532: %USB_HOST_STACK-3-USB_FLASH_READY_TEST_FAILED: USB flash failed to pass 'Ready' test.May...
Hi @Julio E. Moisa ,I can't access this command, since the switch won't really detect the drive at all. The moment i plug the stick into the switch, i get the error mentioned above.
Hello M02@rt37 ,I've just tried formatting the drive as FAT16, which doesn't work either. I get the same error.I've also tried previously using the same Stick on a 9200 Switch, which was instantly detected and worked perfectly fine. So the drive itse...
