Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
When we provision a simple configuration to switch via template (i.e. ACL or snmp credentials), DNAC additionaly provisions some configuration strings which I do not expect:
aaa server radius dynamic-author client IP_A server-key 7 XXX clien...
Hello everyone!
We have reached the maximum load on the L3 out channel on the Cisco ACI factory in the data center.
A decision was made to increase the throughput.
To do this, replace 10GSFP with 25G, and add two more links to the channel.
Since the...
Hello everyone
We have a problem in the ACI fabric with horizontal interaction between endpoints in the same bridge domain, but in different EPGs, between which there are the necessary contracts. Conditionally, endpoints (virtual machines in VMware....
We observed periodic is-is drops via the SRP interface c10720-ATS4 and, as a result, rebuilding of the SRP ring.There is a ring topology:ATS1 <-> ATS2 <-> ATS3 <-> ATS4 <-> ATS1
Connections between elements are organized via direct optical fibers.No ...
Good day!
There is a problem in the ACI fabric with horizontal interaction between endpoints in one bridge domain, but in different EPGs, between which there are the necessary contracts. Conditionally, endpoints (virtual machines in VMware. There is ...
and we have an additional port to simply organize additional port-channel on the 25G links, but how to do it better, I suppose to create test vlan pool to check connectivity, and after that add working vlan pool
We've upgraded to the version 6.0(8f) but problem still the same
and another quiestion - I didn't find the command 'debug cli' on the APIC CLI, and no any description on this command, is this a right syntax?
