Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How can redudant TN3270 server be implemented with 2 x 7206 each with CPA as follows?HOST----CPA----7206(1) |------CPA----7206(2)Can this be implemented using Hot Standby MAC address (HMAC) introduced in 12.(3)?From the following HMAC configuration,i...
I have the following queries for NPE-G1 in handling UDP flooding from LAN to PA-A3:1. Can NPE-G1 support flooding of UDP broadcasting traffic received from LAN to remote sites through a PA-A3 with 250 PVCs each at 256kbps? 2. Will the traffic be ...
Can customer define 2 XCA major nodes with same adapter number in a host connected to a CIP of a 7500? Assuming we have defined 2 LAN adapters of same number in the CIP virtual tokenring interface, how can it identify which adapter is to be active w...
Can dlsw ethernet redundancy support mutliple vlans with the following configuration?host dlsw router1 host dlsw router2 | | local dlsw router 1 local dlsw router2 | ...
What is the maximum number of PUs defined with a single "listen-point IP" for TN3270? It seems that it cannot support more than 4 PUs with a single "listen-point IP" as follows:tn3270-serverlisten-point 1.1.1.1 pu pu1 0012001 token-adapter 2 40 ...
Can the following configuration with 2 or more PU sharing the same IP address?tn3270-server pu A3270PU 05D0100A 10.17.250.1 token-adapt 3 40 rmac 4000.1111.1111 lu-seed A3270L##pu BRAHMPU2 05D76543 10.17.250.1 token-adapter 3 50 rmac 4000.1111...
Hi,Thank you for your information. Do you mena that currently DLSw ER over dot1q interface is not supported no matter on what platform or IOS version? I was told by a local SE that this should be supported by 12.2(6) or later. Is it true? Doe...
I think you misunderstand my question. You are mentioniong the traditional way of dlsw in handling ethernet redundancy. We handled a lot of that for the past few years without any probelm. My problem is on the new ethernet redundancy feature o...
