Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Djibo,
In case you are looking to block the traffic from these hosts on the ASA you need to configure an ACL and add it to an interface via access group
ipv6 access-list <name> deny icmp host 2001:DB8:DC:20::1 host 2001:DB8:DC:30::1
access-group...
Hi,
++ The management access rules are used to permit/deny to-the-box traffic. So if in case you want to block or allow certain users for management access of the box, you can create a rule in this section
++ In your case you have listed the device...
Hi,
From the snippet i can see that the failover configuration on the two units are different
failoverfailover lan unit primaryfailover lan interface failover Ethernet0/2failover key *****failover link statelink Ethernet0/3failover interface ip fai...
Hi John,
From version 9.0, all TCP PAT traffic and all UDP DNS traffic use per-session PAT.
Now if since you upgraded to 9.x code from an earlier one, the per-session PAT feature is disabled during configuration migration. Since the earlier version...
