About daveyg

daveyg · 05-30-2003

Hello - I am worried about my ACL's if someone would be kind enough to have a look at them below.Is access list 150 bypassing 101 and letting evrything else in?Is 101 set up properly to just let out 80,21,25 and 53 out?I have set up a 1600 series 64k...

daveyg · 05-26-2003

HelloDoes anyone have configs for setting up 2 1721's over an ISDN leased line. Also, using ISDN DDR as backup? Any tips or info on additional security that you've put in place and tested would be appreciated. I was just going to put a firewall IOS o...

daveyg · 03-26-2003

Hello - Hopefully someone can help me with this. My clients cant get through one subnet to another. Debug is showing "dispose udp.noport" messages.I have a 3640 with 2 fastethernet interfaces. Int fa0/0 is 10.197.181.0 subnet Int fa0/1 is 10.192.182...

daveyg · 03-10-2003

Hello - I have a 3640 that is segmenting 2 internal lans. There are 2 fastethernet ports on the box. I cant ping one network from the other and vice versa. Even with all icmp access allowed in both directions. I can ping as far as the router on both ...

daveyg · 03-06-2003

Does anybody have a sample config or guideline for setting up a standard firewall between an internal group?The scenario is a 3640, with just 2 network interfaces to provide a firewall to a small network with only 3 clients on it that need access to ...

daveyg · 11-20-2003

Hello This vulnerabilty saved me from manually resetting all my switches a few weeks ago.Point a web browser at the switch. After clicking the Cancel button, enter the following URL into the address bar. http://ipaddress/level/99/exec/show/config Hop...

daveyg · 06-27-2003

Hi LukeI had this exact same problem before with a 3640 series. Even though I've had plenty of room for them. The transfer failed with Cisco TFTP server so I turned on enable logging and it showed a timeout error.I resolved it by using hyperterminal ...

daveyg · 06-27-2003

JD - Do you have a large access list applied? Other things to look at might be the volume of traffic going out through your link. There could be a lot of internet or mail traffic. Have you tested it from a client while no one else is using the intern...

daveyg · 06-25-2003

Put and access group out on your wan interface and then find out what port numbers those 3 app's use. Create an access list with the same number as the access group out to deny them.Or, you could just set up a very restrictive access list and just pe...

daveyg · 06-06-2003

Heres what I used in the end. This is for one side and the other router has the exact same more or less apart from IP's and phone number obviously.Current configuration : 1386 bytes!version 12.2service timestamps debug uptimeservice timestamps log up...

Member Since	‎03-06-2003 06:08 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	19

User Statistics

User Activity

ACL for ISDN 64k DDR query

1721 WAN Link Config

Not Routable

2 Interface IOS Firewall

IOS Firewall between internal network

Re: Admin password lost/not working

Re: TFTP Flash Copy Failure on 3600

Re: Extremely High Latency on Cisco 1700 Series Router

Re: Kazaa

Re: 1721 WAN Link Config