About Carlton

Carlton · 10-19-2023

I received the error, Mainboard hardware authentication failed, Abort init ... after a reboot from the install add command on a C9300LM -48UX-4Y-A switch. Unable to input anything or get a prompt. I’m currently trying to get the SW into rommon Mode,...

Carlton · 06-12-2023

Will two FPR-1010s connect to each other with no issues if one of the FPRs does not use the command listed below? Also, I'm going to apply the High Availability config individually to both devices first and connect them to each other afterwards. Anyo...

Carlton · 05-15-2023

The following copy command that works on the 9500s and 9300s listed below does not work on the Firewalls or the ISR 4330 Series or 8500L routers. Any way to copy from USB to flash with the CLI commands ? copy usbflash0: <file-name> flash:

Carlton · 10-19-2023

I had to press the Mode button 3 times during boot when LED light first flashes to get it to rommon mode. Thanks for input Dustin and Leo.

Member Since	‎05-15-2023 12:14 PM
Date Last Visited	‎11-02-2023 04:01 PM
Posts	4
Total Helpful Votes Received	1

User Statistics

User Activity

Boot to rommon mode after "Mainboard hardware authentication failed"

Configuring HA on two FPR-1010s and connecting them together

CLI copy firmware from usb to flash

Re: Boot to rommon mode after "Mainboard hardware authentication