Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a tunnel I am trying to setup, and I cannot get the traffic to hit the no NAT, NAT rule. It is bypassing the no NAT and hitting the global NAT rule and the traffic, instead of qualifying for the VPN tunnel is going out the egress interface. I ...
I am trying to clean up the NATing to setup a VPN, but the Nats are overwritting the no nat statements. I am trying to clean them to by adding the
source dynamic any interface. The firewall is wanting me to remove them, and I cannot find anything onl...
I have setup a new tunnel between to firewalls, 5510's both of them I used the GUI, set the peers, created the crypto maps in reverse order, set the preshared key, isakmp and ipsec are set. I enabled the tunnel on the outside interface but I am not g...
I have a sub-interface assigned with an IP, name and security zone
interface Ethernet0/1.5 vlan 5 nameif FirewallTransit security-level 50 ip address 10.5.1.2 255.255.255.252
when I issue a show int ip br, it is unassigned, I have tried to rebuild ...
From the firewall I was working on last night, it is trying to pull up phase 1 at leastIKEv1 SAs: Active SA: 1 Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 11 IKE Peer: x.x.x.x Type : user ...
It's 9.1.6 I think... Yes I have tried a shut, no shut, I might try on eth 0/1 and see if that does anything. It did work at first, I re IPed the interface and now this is happening.
