Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am looking for any help, I'm trying to configure traffic shaping on an interface which connects to an MPLS network. The problem I have is that two of our four sites have lower bandwidth connections than the other two. Site A and B are 500Mbps but...
HiReally hoping someone can help with this. I'm trying to setup NATing on a C9300 switch. It's an Advanced license so should be enabled. I'm trying to provide internet access for a guest network so am configuring it in a separate vrf. The config I ha...
Thanks for your reply. I'm configuring the policy on the switch interface which connects to the MPLS router. We have no access to the MPLS router itself.
Thank you everyone for your help, I ended up getting a 930 ISR as a workaround for the issue but was recently working on a PoC for another project and was using vrfs on a 9300 to simplify the setup and stumbled on the fix. I had (quite embarrassingly...
Hi Thank you, it does require a network-advantage license, we have already bought the upgrade and applied it to the switch: ------------------------------------------------------------------------------Technology-package Technology-packageCurrent Typ...
Thank you. I don't have the match-in-vrf available on the switch. I tried swapping the configs around so the other routing table was in vrf and this one wasn't and had the same issue.
Thanks for this, I don't seam to have the Match-in-vrf command available on the switch so. I tried updating it to 17.11.01 but still can't see the command. So, to check if this was the issue, I moved the other routing config on the switch to it's own...
