Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The Cisco ASR 1001-X router does not have a fixed number of SIP channels supported without a license. The number of SIP channels depends on the specific software package and licenses you have installed on the router.By default, the ASR 1001-X router ...
Yes, it is possible to have two core switches with the same SVIs (Switched Virtual Interfaces) configured. This setup is commonly known as an HSRP (Hot Standby Router Protocol) or VRRP (Virtual Router Redundancy Protocol) configuration.In this config...
To block mobile phones on your FTD (Firepower Threat Defense) without using FMC (Firepower Management Center), you can follow these steps:1. Identify the MAC addresses of the mobile phones you want to block. You can typically find this information in...
I have configured my access ports as follows:- The PC is connected via tethering from a phone on the internal switch.- Interface: 2/0/1- Switchport access plan: 11- Switchport voice VLAN: 130In my VLAN configuration, I have set the "ip helper-address...
Hello everyone,I'm excited to join this forum and share my first post. I've been a long-time reader and finally decided to participate.I'm currently facing a challenge with OSPF provision on a multi-router network and would appreciate some advice and...
