Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello !
We are currently testing Cisco AMP as our sole AV (we are moving away for ESET) and was wondering should we just use AMP with Tetra for Workstations or use AMP alongside defender ? (moving to Win10).
Appreciate the answers !
Hello there.
So, we are testing AMP and one thing that I can not change is setting "email scan" to on, I've looked into policies and still can't find the option that turns it on. Actually there is more options that are missing in Policies but are i...
Hello there.
So our ESA has a listener on Mgmt int, it is outgoing mail one (pointed to our exchange). We can get to ESA via ssh or web but only if we are connected to the same subnet as the Mgmt int. Is there a way to enable any subnet to access i...
Hello there.We are in the middle of cutting old mail addresses and just using new one. Already configured bounce message if LDAP doesn't find recipient. Is there a way to customize these messages with including new email address?Or maybe there is a w...
Hello Ken,
I think with Your help I have found the problem, routing table has only DMZ default gateway (Incoming mail listener) but nothing for our inside int (Outgoing one), adding ip route <subnet> via <internal router> shouldn't mess things up (...
Hello Matthew,
Finally found time to play with it and this time I've created separate mail policy (instead of applying it to the default) and also change condition from "equals" to "contains" and it worked (I think problem was with "equals").
Tha...
This is the error message I am getting back. The rest I can check tomorrow and will get back for sure! Appreciate Your help guys!
Delivery has failed to these recipients or groups:
[email protected] ([email protected]) The e-mail address you ente...
