Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am just a starter in CCNA. I want to configure Nat in R1 according to below typology. I do not know how to configure between Multilayer switches that act as a router. I need help. PLEASE help me. I will accept any suggestions.
Thank you for your answer My switches doesn't support NAT but the switches are L3. I can configure eigrp and rip but not ospf. Now I wonder, will the switches know how to get to wan router ? If I configure default route on the router that connects t...
Thanks U. Let me explain what my teacher want me to have configure in this scenario. I configure ospf between L3 switch and Router1 (I do include serial link IP address). Default route between Router1 and Router2. my teacher want me to configure NAT...
