Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We created a new IC to our building that I installed two 2950_48 that are stacked together. Off from one of the 2950 is a fiber that runs back to a 3548XL switch for our trunk connection. I configured trunk on both ends and set vlan 2 as our native...
I am having problems with some of my machines on the different vlans get to the resources at my central site. I have a 2621 as building router then connected to the 3550 (vlan routing box). 2950s uses for access switches. The strange thing is that w...
I configured my 3550 for VLAN routing. I have 5 vlan configured. I changed my native/managment vlan to vlan 2. All my vlan is configured with the correct address for gateway for each of these different vlan/subnet. When I do a show ip route it sh...
I have a PIX 520 as device terminating VPN tunnels. I able to establish a IPsec connection. I verified that I was given an address in the IP pool that I configure but I cannot get to any resource on the internal network. I could only ping myself. ...
I converted our PIX configuration this weekend from conduits to ACL. Then we started having problems. Our problem is that we cannot resolve our DNS to our web server which is in the DMZ, which also has static map address public address. When we att...
Thanks for the prompt response. I pasted the config for both switches. At the end of the switches is the show int vlan 2 output. I was wrong earlier about the output of vlan2 up and line down. Both vlan2 and line is down. Please look at both conf...
Joe,You are right. I got the problem fixed. I went back and added vlan 2 to the vlan database and it worked. Configuring a SVI does not create it in the vlan database automatically. I thought I did that already. I must have missed it for vlan 2....
Here is the result of different vtp commands. Let me know if you need more info. show int trunkPort Mode Encapsulation Status Native vlanGi0/1 on 802.1q trunking 2Gi0/2 on 802.1q ...
