Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, With ACI verion 4.2(i) and vCenter 6.7, I'm trying to install Cisco AVE in the vCenter. I followed the steps in the "Cisco ACI Virtual Edge Installation Guide, Release 2.2(x)", but when I get to "Cisco ACI Virtual Edge Installation Using the ...
Hi, In a lab environment the only APIC crashed without any known reason (so far..)and we had to restart it. After that all seems to work well except the VMM Vcenter integration. The faults we get are: F16438[FSM:STAGE:RETRY:]: Connect stage for VM ...
Hi,
after upgrading ACI fabric to version 3.2(4e) I get this Fault on one leaf and one spine:
If I clck on "reload the switch" a dialog box emerges asking for confirmation and with a check-box option for "Update SSD".
Has anyone got this probl...
Hello,
I've read (and checked in our fabric) that there's no IP EP Learning on infra VLAN, and I would like to know the reason for this behaviour. I've looked for it into the documentation but I haven't found an explanation.
In this case, when only...
Hi Chris, the connection between the leafs and the FIs is option 4. I have to check for the vSwithc, I really didn't pay attention to that and it may be the problem. I have to find time to check all the configuration. Thank you very much for help.
Hi Chris, after doing more troubleshooting I still haven't found the cause of my issue but at least I found a workaround. The iESX server is installed on a UCS C-Series integrated with UCS Manager. The fabric interconnects are connect to the leafs wi...
Thanks Alejandro for your reply. I also tried to restart the vmmmgr process but it still not working. I'm going to test adding a new vcenter with new name and IP. Regards
Hi, thanks for your reply. I tried that but same faults. The thing is that later I found that the APIC was having problems with the lldpad process. To solve this issues I had to upgrade the fabric, and for a while it seemed to work but when I finish...
