Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Introduction
This document will run you through a step by step configuration example of Inter VRF route leaking in Cisco Application Centric Infrastructure(ACI). This article describes the steps with screen shots of example configuration and some ve...
This document describes the steps to be followed to add a new leaf or spine switch to the ACI fabric.
When you unbox the new switch, note down the serial number of the switch. Power on the switch and connect a console to check if it is running in ...
This document describes the steps to be followed to replace a leaf or spine switch to the ACI fabric.
When you unbox the new switch, note down the serial number of the switch. Power on the switch and connect a console to check if it is running in ...
IntroductionRequirementsRelated Information IntroductionThis document provides a sample configuration of Direct Attached Storage (DAS) in the Cisco Unified Computer System (UCS). In versions of UCS earlier than 2.1, you had the option to use DAS with...
Hi Nikhil,
From what you mentioned, you don't seem to have that IP in use anywhere in your network. I am suspecting, this could be a proxy response from one of the interfaces in your router. The installer does a check of this 169.254.x.x IP using t...
Hi Rohit,
HyperFlex edge cluster is intended to be deployed without Fabric Interconnect. There are different use cases for an edge cluster and standard cluster (i.e with Fabric Interconnect).
Edge cluster can be deployed using Intersight SaaS ve...
Yes, as of now multiple DHCP servers behind the same EPG in same Provider policy is not supported. Instead, you can create a second policy for the second server and attach multiple DHCP relay policies under the client BD.
Hope that helps.
-Ganes...
Hi,
Can you please check and confirm if the IP is learned as an EP in the leaf by running the command "show endpoint ip <ip>". if it's learned, the command you tried to clear the EP looks alright. Just make sure that you are in vsh shell while runn...
Hi,
I believe you are referring to how to identify a remote endpoint and find where it is learned from.
As you are already aware, fist this is to find out the tunnel by running "show endpoint" command. Once you have the tunnel number, you can us...
