Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I was trying to downgrade my FPR-1010 to 7.0.5-72 from 7.2.8 to upload a config file I have but disk0 on the firewall does not see the firmware. I currently have it on a usb drive and tried to boot the image that way but when I do, I cannot exe...
i currently have a Cisco 9200 catalyst switch that I am working on for my current employer and I am unable to access the Web UI when i type in the IP address assigned to the switch. Every time i type the IP address into a web browser, the switch read...
I have a config file that runs on 7.0.5 and I was trying to downgrade it so I can run the baseline config file I am using to later upgrade to 7.2.5. I typed in 7.2.8 on accident so my apologies. I did look at this but I think I overlooked one step. L...
I disabled https and it works with http. When I try to use https, i get an error message that reads "private key not found" when I am consoled into the switch.
