Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1) I have 5 buildings2) They can not see to each other3) But they can see a mast in a mountain4) Distance between buildings and the mountain is 3 kmQuestion is...How many BR350 do I have to use?How many and what type of antennas do I have to use?I ne...
I have two AP 350 connected to a Catalyst 2950 at VLAN 3.This is the problem... if one user is working with his notebook (connected to AP 1) and starts walking to the other office so AP 2 would have to take control of the connection... how does Catal...
How do I set to 0 the aging time mac address table for a VLANn?I know that I can do it to all VLANs but I am only interested in one VLAN. I want it to have...mac address-table aging-time 0 VLAN 2 (but this command is not recognized by IOS software)I ...
Thanks a lot for your answer...But I have got another question for you...I am not so sure of what find of antenna should I use.Consider that there is a distance of 3 km from the mountain to the last building...help me please...Thanks!
Here it is what I was trying to tell you.At this link you can see a mistake from Cisco... http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a008014f296.html#1051018At the "Managing the MAC Address Table" s...
Yeah, we are working with Catalyst 2950 series.I think this is a misstake from Cisco. They are telling at their site that it is possible to set the aging time to 0 for a specific VLAN.
Cisco says that it is possible to do this for a specific VLAN.This is exactly the command from global configuration mode:mac address-table aging-time 0 vlan 1ormac-address-table aging-time 0 vlan 1but when I try to configure it... the IOS tells me th...
