I have setup a link aggregation between 2 Cisco SG300 network switch. I had assign port 1 and port 2 (both are Gigabit port) as a member of LAG1. From the Cisco switch GUI,it is shown that the both port is an active member. In this case, will the LAG...

I have a Cisco NSS2000 which act as our backup storage. We run our daily backup into a share folder inside the NAS. But after restart the NAS last week, the existing share folder is missing. I had reset the NAS and rebuild the volume (delete the exis...

I have learned that by default the ip helper-address will forward the following 8 udp portsUDP PORTCommon Name.69TFTP67BOOTP Client68BOOTP Server37Time Protocol49TACACS53DNS137NetBios138NetBios DatagramBut when I check in cisco SG300-28, only port 37...