Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I installed software version 9.1(2) on my ASA 5505, but I cannot establish a L2L VPN to a PIX 501 6.3(5). I'm wondering if those software versions are compatible for what I am trying to do. Before I upgraded to 9.1(2), my ASA had version 8.2(1) and t...
Every time I add a tunnel-group for the Cisco VPN client, my L2L VPN's stop working. Below is my currently working config. Would someone mind posting the commands I need to add to enable the Cisco VPN client to connect while allowing all current co...
Can a PIX 501 6.3(4) establish a VPN to a provider such as www.privateinternetaccess.com? They claim to support PPTP and IPSEC/L2TP. If so, how would the PIX need to be configured?Thanks.
Would someone mind glancing at my configurations and helping me to understand why I can't establish a VPN to pse-pix-outside? VPN's to all other PIX's work just fine, and RDP, SMTP, and DNS traffic is properly mapped to the server 192.168.50.2 and w...
Below is the configuration of a PIX 501, which I want to accept connections from VPN software clients. I can successfully connect to the PIX using the VPN client 5.0.0.7.0290, and I can ping the PIX at 192.168.5.1, but I can't ping or connect to any...
Thank you for looking at it. Here are the configs:User Access VerificationPassword:Type help or '?' for a list of available commands.sillspix> enaPassword: sillspix# sh conf: Saved: Written by enable_15 at 18:22:59.005 UTC Thu Sep 12 2013PIX Version...
From the 192.168.3.1 PIX, here is the output:chris-pix# sh cry isa saTotal : 1Embryonic : 0 dst src state pending created don-pix-outside 172.27.35.45 QM_IDLE 0 1chris-pix# sh cry ipsec...
Thank you for your reply. It did in fact work that way. For future reference, the "gateway" address that Qwest listed when I ordered the block of 8 ip's, was the address that the PIX received when connecting via PPPoE.
