I have two offices with their own internet access and are inter-connected by point-to-point T1s. I am trying to set up an alternate or redundant path from the internet. There are a bunch of other factors, but here’s what I am trying to accomplish:T...
When my FiOS was installed, I had already requested that it be installed on the Ethernet cable. Don't know that they have to do anything to allow you to switch over from Coax to Ethernet. The easiest way to test it would be to find the media conver...
Yes, if the FiOS router is in bridge mode, then your PIX would pull the DHCP address and it could work. And yes you wouldn't be able to use the built-in wireless function while it is in bridge mode.You mention that the PIX with the dynamic IP would ...
You will not be able to do this unless you set your PIX 501 to be in the DMZ of the FiOS router. The only problem is that if your FiOS router has DHCP, then, if, Verizon every assigns you a new IP, you will have to update all the remote PIX/VPN Endp...
If you want this route map to apply in both directions, then you have to apply the 'ip policy route-map newnew' to the interface that is recieving the traffic from 172.27.200.100. Try that and see....
