Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having a bit of trouble determing the best way to do this... I have 12 VLANs set up (subinterfaces on a redundant group of two NICs) on my ASA 5510. On several of these, I want them to be able to access the internet but not access other VLANs. ...
I would normally do this inside of the network on our switches, but we want to allow connections only from a specific ip to a specific ip on a specific port, so the only option was to do it in the ASA. I created a redundant interface on the ASA, and...
Same question here. We were planning on mandating Meraki at client locations, but given this news, I'm actually having to back-track and investigate alternatives to present to clients who want VMWare virtualized firewalls. Kind of sucks since it wa...
I had a route set wrong on one of the boxes, which was the last problem. All in all, I had to do the following:Set the security level of both interfaces to the same numberCreate ACL for ServiceBureau (incoming), allowing access from the ServiceBurea...
I have to exclude some information:: Saved:ASA Version 8.2(5)!hostname esp-asa01domain-name xxxxxenable password xxxxx encryptedpasswd xxxx encrypted...!interface Ethernet0/0 nameif outside security-level 0 ip address ComcastInterface 255.255.255.240...
I tried that as well as intra-interface. One thing I noticed is that if I try to connect to the IP on the other vlan, the logs say that the destination is on the "outside" interface, but the actual network is configured on the "ServiceBureau" interf...
