Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello team,We are planning on upgrading our cisco cat9300 switches from 16.11.x to 17.15.xThey are currently running on BUNDLE mode, we plan of changing it to INSTALL mode and proceeding with the upgrade.However, I found that there is a bug ID: CSCwh...
We are currently planning an upgrade of our cat9500-484YC switches. The switches are running SVL between them and current running version is IOS-XE 16.12.1We are planning to upgrade it to IOS-XE 17.15.x.The current ROMMON Bootldr version is 16.12.1 a...
Hello everyone, We are running into on an issue on our FMC and FTDs.Both currently run the 7.6.4 version. The issue is that the FMC is showing one of the interfaces on the Active firewall as DOWN. CLI confirms the same, that the interface is currentl...
Hi team, I have read up on this particular vulnerability and had a few doubts. For ASA software version 9.16(4)200, I cannot seem to find this particular release on the cisco software checker page. Anyways, is 9.16(4)67 a higher or lower release when...
Hi Leo, I meant, convert the 16.11.1 to INSTALL mode and within the same window (without a reboot), go with the INSTALL commands and move to 17.15.xAs in, one reload that’ll do the conversion and the upgrade to 17.15.x ?If that’s possible?
Thanks for your reply Leo, however, what we are planning is; to first convert 16.11.1 to INSTALL mode, and then move to 17.15.x My question is regarding the BUG workarounds given, will converting to INSTALL mode be enough? or do we have to go through...
Thanks for your reply Leo, however my doubt still stands. Are both of the workarounds to be performed? Or is it OK to first convert to INSTALL mode, then proceed with installing / upgrading to 17.15.x from 16.11.x ?
Thanks for your reply Stefan! Just to confirm, during the upgrade, if everything goes smoothly, we wouldn’t need to upgrade the ROMMON correct? When would we actually need to upgrade it manually though? Thanks again