Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a couple of questions about this network. This is a part of configuration finishing with the error that stopped me.S1(config)#vlan 10S1(config-vlan)#name vlan10S1(config-vlan)#exitS1(config)#vlan 20S1(config-vlan)#name vlan20S1(config-vlan)#ex...
If I make the other network (10.1.1.0) between the router and L3 switch, can I make it work (having the vlan10:192.168.0.0 and vlan20:192.168.1.0 on both sides), by configuring the ripv1 routing on both L3 switch and R1 router. And if so, how should ...
Network as it is is working now, but I noticed you changed some IPs on end devices.Shouldn't the PCs on the same VLAN has IP addresses of the same subnetwork? Also you used 255.255.255.128 as a subnet mask, but that doesn't count as class address (A:...
So what you're saying is I don't need subinterfaces or what? Sorry I didn't quite get it.And about the other thing, you mean I don't have both vlans created on each switch that I configured with trunk ports?
