Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a FPR1010 managed locally ( FTD ) with Anyconnect setup with Azure SAML configured as authentication. I am using the recommended software version.
I get the Authentication failed due to problem retrieving the single sign-on cookie erro...
Hello,
All of a sudden some of my ASAs using VPN with SAML/O365 gets the error authentication failed due to problem navigating to the single sign-on. My sign-in logs on Office365 says that the authentication was successfull. If i login via a brow...
Hello,
Perhaps this is a really stupid question I have tried to understand the information out there but no ( new to the EWC )
When you enable AX high throughput on these APs will that automatically force the channel width to 80 MHz?
Cheers
Ma...
Hello,
I have a Wireless network with 8 9115AX APs running with embedded wireless controller. The software is 17.8.1.
I have some random reboots on every APs from time to time. I see that this firmware has some open caveats regarind unexpected reboot...
Hello!
I am trying to clarify one thing regarding blocking files with the malware part in firepower. Is the SMTP filter part only for uploading and not downloading. Does that mean that incoming SMTP is not inspected by the FirePower? That seems...
Hello,
well i tried to set it globally and also a rf profile that i used on my wlan. I still got stuck in 80 width. Perhaps its netspot pro showing it wrong.
Aha ok,
17.9 does that even exist? Either way i will change the software. ITs a very simple setup so i assume that downgrade should be possible?
Martin
Sorry,
What i meant was that your provider points the new block of address to the existing configuration in their router. So basically you can start using them right away, for example configure a new static nat rule with one of the new IP´s.
e...
Hi,
Sorry i read the question a bit fast
Just use the block for the service you need, for example new rules. The ISP points the block to your existing setup.
Martin
What i want is to inspect incoming emails and the attachment. I know it´s not a spammodule but looking in to the attachements coming in via SMTP would be good. But reading the SMTP part make me a bit confused.
Martin
