Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello folks,I am trying to block messenger using Zone-based Policy for certain users from the local network. This is still lab environment recreation for a customer. It does not seem to work and I am not sure this is the right way of doing this in th...
Hi experts,My customer wants to allow messaging just for certain users IP and block it for anybody else. His configuration is something like the following:class-map match-all msn match protocol imap match access-group name Permited_MSNip access-list...
Hello Experts,I have a customer who wants to add a second interface in the router for a second the ISP connection. Basically, he wants use this new connection in the DMVPN cloud so the spoke router can access both interfaces adding a second static ip...
I have a customer who has this PPPoE configuration below, not I am not sure it would work. interface GigabitEthernet0/0.1 encapsulation dot1Q 1 native ip address x.x.x.x 255.255.255.0interface GigabitEthernet0/0.10 encapsulation dot1Q 10 pppoe enabl...
I tried this, but it did not work. ip local pool testpool 10.0.0.10ip nat inside source list 100 pool testpool overloadThe ip nat pool gives me this:C1841(config)#ip nat pool patpool 10.0.0.6 10.0.0.6 netmask 255.255.255.255%Pool patpool mask 255.255...
Thank you Andrew!I figured that this configuration had nothing to do with what the customer wants. I am now configuring using the zone-based policies. Configuring an Instant Messenger (IM) Policy http://www.cisco.com/en/US/products/ps6441/products_fe...
