I have a template generator built in PHP, VTL, and I have also tested Jinja. This setup works well for generating Cisco CLI templates offline with the exact configuration structure I need, doing this since years..Currently, I apply these configuratio...
Hello Team,I recently implemented an FTD Firewall managed by FMC, primarily using it as a VPN concentrator for internal subnet access.Here’s my current configuration:I created two connection profiles, each assigned to a specific Group Policy.Under th...
Hello, I was using ultraconfig website to generate my templates CLI based on JINJA of the router but I just wanted to move to different ways like NSO/Ansible to improve automation of it and maybe someday full orchestrate. I started using NSO and make...
Hi Mohammad,The RD (Route Distinguisher) makes routes unique inside the router, while the RT (Route Target) controls which routes get shared in an MPLS VPN. RD doesn’t affect sharing, but RTs must match (export on one router, import on another) for r...
Can you try in following way? It should modify the route once is under vrfroute-map ADD_RT_IN permit 10match ip address prefix-list TEST_BGP_INset extcommunity rt 31655:2000 additivevrf definition INTERNETrd 31655:100route-target import 31655:2000rou...
Hi @Muhammad-ly , it is not possible to configure two service instances with default encapsulation under the same physical interface.However, you can work around this by using untagged encapsulation as an alternative, if tagging is not required.If yo...
Hi @n_abromov This seems like expected behavior. You might be able to influence the path selection by creating an SR-TE policy from R1 to R5 with an explicit path using a Binding SID at P2. This way, you can ensure that the labels used in the tracero...
