Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking to change my timeout value from default of 120 seconds to 60 in controller based SDWAN. Running 17.12.4 on the edge and 20.12.3.1 on the controller. I don't see a readout in show sdwan run but I do see it in show run all. I have many ed...
On the SDWAN routers that are in controller mode, I need to remove HMAC-SHA1 from the list of options for SSH to connect. Is there a template that would be used to modify SSH, like a CLI template. I am looking to push the equivalent commands down to ...
I am slowly decreasing my "Total Output drops" on the interfaces on my stacked Cat 9300s with the global command "qos queue-softmax-multiplier xxx" I started out with 300 and have been jump up by 100 and I am at currently 900. There is only a few int...
Yes, it is definitely platform dependent for this command. It wasn't on my Cat9300 but on my SDWAN routers I have the command on IOS-XE running 17.12.3a.hostname-4331#sho run | inc ip identdhostname-4331#sho run all | inc ip identdno ip identdhostnam...
My switches are running 17.12.4 and I too am going thru a CIS audit requiring proof that I have turned off a command that does not exist anymore. I am going to open a TAC case and ask for evidence and documentation to present to my auditors. I canno...
Thanks for going the extra mile and loading up 20.13 and 17.11. This is what I love about this community. I opened up a TAC case just to hear it from Cisco and now I have documentation. There is a bug with SDWAN and not being about to change SSH sett...
Thanks Kanan. This was my original thought but I didnt find the commands in the qualified command list. I figured I ask here first because my deployment doesnt have a test site to test features like this.
Thank you for the link. Does it matter that these devices are cEdge and not vEdge like the document references? I log into vManage SSH Terminal with a local account but still can not issue "config t" because the router is in Controller Mode. My vMan...
