Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How to run CLI commands over a remote CLI to CUCM using its IPv6 address? The CLI works for a CUBE over IPv6, but have been unable to successfully execute CLI by connecting to IPv6 address of a CUCM. CUCM is enabled for Ipv6. Cannot find any document...
This is the description of the sip-hdr VSA: Arbitrary message header from the incoming request. Includes the complete header line. Whether a message header is included in accounting records is controlled by the configuration.
How to configure a parti...
Thanks for your reply Roger. Agree with your statement that it is best to assume "Not supported" when there is no documentation that states it is supported. When I googled for "SSH Support over IPv6 for CUCM" I get this "gen AI" comment: "While Cisco...
