Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Where can I get REAL technical information about Spark Board and supporting components and systems. All I can seem to find on the Cisco website is generic rudimentary advertising. I support the video Cisco material throughout American Eagle Outfitt...
we have 6 ceiling mics in an area where we would like to place an SX-10 or 20. As you know, the line input has a direct loop out to the live speakers. We need the mics to NOT be heard live as input on the line input. We need to use the MIC level i...
I recently upgraded a SX-80 from 8.3.1 to 9.1 operation software. The camera and touch controller upgraded nicely, as well.
Question: Is a downgrade back to 8.3.1 easily done to that same unit? And will the camera and touch controller (dv-10) go a...
If we use In Room Control to create a button on the DV-10, and use an xAPI to start the codec begin call function, wouldn't that complete the initiative? We want to use an email "name" followed by our in-house name command string for WebEx calling,...
The codec jack for Mic input is typically a four conductor, one of which I assume is for "mute". However, the number of conductors for the output of the mixer is THREE (Left/Right/LOW).
Do you have an illustration as to how the four conductors "me...
Patrick---
The codec jack for Mic input is typically a four conductor, one of which I assume is for "mute". However, the number of conductors for the output of the mixer is THREE (Left/Right/LOW).
Do you have an illustration as to how the four co...
Excellent-
Thank you , Patrick
I will assume that I need to do the downgrade via the internet connection, in the maintenance section. The upgrade was done through TMS, which I have not found a place to go down in software.
thanks again
