Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I went to set a static IP address for the new switch by clicking on the pencil via the LAN IPv4 address like we normally do for the switches we have running CS firmware but it then comes back saying :Configuring a static IP requires the following ste...
Quick question , when connecting a brand new C9300M switch to the dashboard for the first time can you go straight to IOS 17.18.2 or should you install CS first and then upgrade ?
We are just about to start the swap out (so same AP name . same location just newer model) over 3000 AP's in over 300 locations and currently can not see a way to simplify the updates to the floor plans. Unless I am missing something I will have to r...
Reading through the Meraki doc "High Density Wi-Fi Deploymens" one of the calculations it mentions is"Number of Access Points based on throughput = (Aggregate Application Throughput) / (Device Throughput)" I just wanted to check that device throughpu...
@joey.debra & @danjns - Thanks for this reply thread. I should say I have used both Airmagnet and Ekahau for designs and appreciate what I am asking is all based around theory rather than real world. The area we are currently planning for is a "hi...
What is the "Addressing and traffic options" you have set for that SSID as 802.11r will be removed as an option if they are set to either "NAT" or "Layer 3 roaming" ?
