About mHAJ

mHAJ · 08-07-2023

Hello Guys,I hope you can help me with this issue, I have this topology with 4 routers running BGP which i want R1's Loopback 1 to have the R2 as an exit point and R1's Loopback 2 to have the R3 as an exit point. With which attribute can i achieve th...

mHAJ · 08-08-2023

Yeah i just did that on R4 but not with MED but with Local Preference and it worked perfectly sending traffic for 1.0.0.0/24 through R2 and traffic for 2.0.0.0/24 through R3 : Network Next Hop Metric LocPrf Weight Path*> 1.0.0.0/24 ...

mHAJ · 08-07-2023

I tried this suggestion with a small change to the command: " neighbor 12.0.0.2 route-map R2 in "changing it from in to out because it showed me this:R1(config-router)#neighbor 12.0.0.2 route-map R2 in% "R2" used as BGP inbound route-map, route sourc...

mHAJ · 08-07-2023

Yeah sure, also need to confirm that communication is good i have load balancing in R1 but i just need this Manipulation to be done in R1 and im not sure if i should do it with weight or Local PreferenceR1interface Loopback1ip address 1.0.0.1 255.255...

Member Since	‎08-07-2023 03:41 PM
Date Last Visited	‎10-05-2023 10:01 AM
Posts	4
Total Helpful Votes Received	1

User Statistics

User Activity

BGP outbound traffic manipulating

Re: BGP outbound traffic manipulating

Re: BGP outbound traffic manipulating

Re: BGP outbound traffic manipulating