Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are trying to setup a AP Mesh topology between our two sites with WLC 9800 but it doesn't worked yet. and aslo we don't have the Mesh menue under Configuration > Wireless >Access PointsWLC: 9800 Amsterdam,17.3.4cAP: C9115AXEWe followed the instuct...
Hi, how did you resolve the issue? we have the same issue, the device connected to the Guest ssid, and as soon as we connect to the Gues SSID it brings up the guest web portal and we can type our credentails and it start autenticating but after 5 sec...
The error "Disjoined AP Auth Failure" shows that the AP is trying to connect to the WLC but it is not able to authenticate, I had a little bit similar issue but when I removed the separators ( . - from the MAC address the issue was resolved. In the...
Thank you marce1000, for your support, your resources were very helpful and my last problem was in the the MAC address. because I was entering the MAC Add with separators and it prevent the AP from authentication.
Hey Rich R,Thank you soo much for your support, it worked. my mistake was that as you said I was entering the AP MAC Add with separators as it was is in the AP. now I have a Mesh AP.Thank you,
And the MAC address are good there is noting worng with adding the MAC it show like that becouse i brought some canges to the MAC in the screenshot becouse I shared the screenshoots in public
