Documentation discusses "1-Gigabit Operation", where all 4 1-Gig SFP's on Sup7L-E are enabled. But it does not say __how__ to select either 10-G or 1-G operational modes. Please help! I have searched & searched, & cannot find any mention of how ...
IP address of Primary had to be changed, to respond to a hardware failure of TACACS server with IP in many device configs. Now the Secondary fails to respond to repeated "Deregister from Primary" requests, even after reload - apparently because i...
finally found it. Syntax is, conf thw-module uplink select gigabitethernetendmsg is generated: "A reload o fthe active supervisor is required to apply the new configuration."
