APs are 2800 series and I have found the same warranty as for 3800https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-2800-series-access-points/datasheet-c78-736497.html#Warrantyinformation  The thing is that I`m not the original end u...

Is there any other way to fix this 2 APs?I do not really have the option to contact TAC, I bought used APs and I do not have a valid contract with Cisco.Thank you!

 Hi Leo, Both APs are in a U-Boot loop.One AP has the below behaviorI have switched the boot partition usingsetenv boot path2 / path1 && saveenvu-boot>> printenvBOOT=path1 (part1) or path 2 (part2)I get this resultu-boot>> bootNAND read: device 0 off...

Hi Leo,   Thank you for your reply   u-boot>> setenv mtdids nand0=nand0 && setenv mtdparts mtdparts=nand0:0x40000000@0x0(fs) && ubi part fsnand0: partitioning exceeds flash sizemtdparts_init: no valid partitionsError initializing mtdparts!  Let me ex...

Hi, I`m facing the same issue with an AIR-AP2802I-E-K9. It is stuck in U-boot and I cannot do anything. Since you managed to fix the AP would you be kind and share the actuals steps you took? Thank you!