About freeyorself

freeyorself · 05-11-2017

I have an IPSEC tunnel established between a Cisco ASA 8.2 and an AWS VPG. I cannot get traffic to route across the tunnel. I do have all the ACL's inplace but what is required to route traffic across this tunnel is my question here? I don't see a r...

freeyorself · 06-01-2017

The last one...my original config :) Issue was routing setting on AWS end. Needed to enable route propagation for the route table set for that VPN.

freeyorself · 06-01-2017

Figured it out!! literally "just a check box" On AWS side needed to check the option to propagate routes for the route table to include routes set for the VPN.

freeyorself · 05-23-2017

Thanks for your reply Georg. This is now what I have in place. Still I am unable to ping remote host.

freeyorself · 05-12-2017

Tried that. Below is the config. To confirm there is now route statement for the remote private IP address correct? The ACL's take care of that? namesdns-guard!interface Ethernet0/0 nameif outside security-level 0 ip address <*Public IP*> 255.255...

freeyorself · 05-11-2017

I'm trying to use static routes. I followed the guide you mentioned but see no configs for static routes. I tried entering several but none seemed to work. I'm guessing my NATing is an issue and I have no route to the private IP of remote site. L...

Member Since	‎05-11-2017 01:16 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

IPSec VPN Routing

The last one...my original

Figured it out!! literally

Thanks for your reply Georg.

Tried that. Below is the

I'm trying to use static