Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I've set up anyconnect on a 800 series router succesfully. VPN clients can reach LAN addresses fine. LAN clients can also reach VPN connected machines, except from the router itself.They are on the same subnet (10.10.10.0/24). Tunnel mode is sp...
Hello All,I've got a problem with my AP on 2.4GHz.It shows maximum 14dBm max TX power which is less than the specs.Country is Hungary which should allow more TX power.Is there any limit or hint or advice?AP works as ME mode.Many thanks!
Anyconnect listens on Cellular interface (LTE router). When I connect via anyconnect (cellular pulbic IP) I got an IP from the defined VPN pool. (10.10.10.80 10.10.10.90). I can reach any local address including routers' 10.10.10.1 from the VPN clien...
Hello,Thanks for the suggestion.I've added the following but still cannot access the VPN client from the router.ip access-list extended vpn-clientpermit ip 10.10.10.0 0.0.0.255 anyline vty 0 4access-class vpn-client intransport input sshBest regards,...
Hello,Thanks for the detailed explanaition.The software version is 8.10.151.0. As I checked the excel the "-E" marking is for 14 dBm max in 2.4, so there is no issue with the equipment nor the settings, this is the maximum allowed power which "E" can...
