Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have these new IBM laptops that have the Intel 1000Pro gig cards. When we connect them to any of out catalyst switches (4006 or 2980) it takes about 15 seconds to negotiate something. But when I connect it to a cheep SMC switch it does it in abo...
We have just started to notice with a new set of laptops that when we installed CSA ver. 4.0.3.720 or 4.0.3.728 it takes up to 30 seconds to get the log in screen. These systems are XP fully patched with sp2. I've also started to hear a few other p...
Could you direct me to the document on how to move the MC from one machine to another? I got the appoval to get a server licence to move this on. Thanks for the help.
Is 4.5 the MC for the Agent? I didn't see a 4.5 agent out there. Does the MC really make that big of a differance? In the pdf it says that it needs W2K server do you know if maybe it can running on a high end W2K Pro machine? That's what we curre...
OKAY not sure why this happen but when I was messing around with the port I cleared it and it disabled portfast. So I enabled portfast again and now it's working a million times better. Now if I can just figure out the problem with CSA. :<
Doesn't CSA need that shim? I already have ICF disabled along with a million other services and we are running TrendMicro AV. I'll try to load CSA with out the shim to see if that helps.
I tried to set one side and both sides to the same and it didn't help. I'm not quite sure how to check to see if the port is longging anything. The delay is showing up in two different ways. When I boot up and log in as soon as I get a log in scre...
