Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Is there any command to check the HA status in cisco ISE using CLI. I want to know whether the particular node is acting as primary or secondary using cli?
Thanks and Regards,
Naveen
Trying to permit interface range in command set for allowing particular port to be accessed other should be blocked. I Tried
FastEthernet 0/([1-9]|1[0-9]|2[0-9]|3[0-9]|4[0-7])$
It's not working. Tried to allow show running-config interface 0/1 to 0/...
Thank you Rahul,
How to get email notification, I have scheduled the report. Report are generated and saved in TFTP server. I configured SMTP also, but I am not getting notification Email.
Regards,
Naveen
Hi,
can you pls help me to resolve this,
Trying to permit interface range in command set for allowing particular port to be accessed other should be blocked. I Tried
FastEthernet 0/([1-9]|1[0-9]|2[0-9]|3[0-9]|4[0-7])$
It's not working. Tried to allo...
Hi,
Facing same issue in ISE command sets also, did you get answer. tried searching many doc. still it's not resolved. Pls help to resolve this.
Regards,
Naveen.R.B
